Spray gun for cleaning of FAP - ERC particulate filters
The cleaning gun for FAP allows both cleaning and rinsing of the filter, eliminating accumulated soot and ash deposits. The cleaning concentrate can be sprayed directly into the FAP via the opening of the pressure or temperature sensor. Cost-effective solution for clogged diesel particulate filters that significantly reduces costs by avoiding premature replacement
Instructions for use:
Step 1: If possible, place your vehicle on a lift. The diesel particulate filter should not exceed 40°C.
Step 2: Connect the feed hose with the special foam nozzle to the pressure gun.
Step 3: Fill the pressure gun with the required amount of TOP PRO - FAP CLEANER #1 (DIESEL) | ERC (refer to the instructions on the back of the bottle).
Step 4: Remove the pressure or temperature sensor located before the particulate filter.
You can also remove the diesel particulate filter to clean it outside of the vehicle.
Step 5: Insert the nozzle into the appropriate opening, facing the particulate filter.
Step 6: Connect a compressor and adjust the operating pressure to at least 4 bar (a 4 bar pressure reducer is built into the pressure gun).
Step 7: Spray the required amount of cleaning concentrate directly onto the surface of the diesel particulate filter at intervals of 5 to 10 seconds, with a pause of 5 to 10 seconds between each spray. To clean the entire surface, move the hose with the foam nozzle back and forth. If the filter is clogged, you can remove it and clean it outside. Let the product work for 10 minutes.
Step 8: After cleaning, rinse the filter with the rinse aid: TOP PRO - FAP RINSE AID N°2 (DIESEL) | ERC. Use half of the bottle (500 ml). Place a container under the exhaust to collect the liquid. Run the engine between 2,500 and 3,000 rpm until all fluid is removed.
If necessary, repeat with the remaining 500 ml of rinse aid.
Step 9: Reassemble the pressure or temperature sensor (or particulate filter) and check for leaks. After rinsing, run at high speed for at least 20 minutes to complete the filter regeneration. The process is environmentally friendly, with no residue on the cleaning product.
Step 10: If regeneration has not occurred after 20 minutes of driving, it must be done manually using a tester.
Important instructions :
- Wear protective goggles and gloves.
- Check the oil level before cleaning. If the level is too high, change the oil (risk of dilution by fuel).
- Replace damaged or overheated particulate filters.
- Do not heat the engine. Filter temperature should be between 30 and 40°C.
- Blow the differential pressure sensor lines with compressed air after rinsing.
- Check the error memory. If no regeneration occurred after 20 minutes of driving, manually run it with a tester. When performing static regeneration, follow the manufacturer’s safety instructions (fire hazard).
Related products :
cleaning liquid DPF n ° 1 | ERC
Rinsing liquid DPF n ° 2 | ERC