



The universal cable is used as a bench to connect the AutoTuner tool to the ECU socket without having to open it. This is the improved version compatible with the micro pins of the Bosch MDG1 ECUs.
Secure payment - Information protected
Fast delivery - 90% within 2 to 3 days
Returns within 14 days
Some ECUs can be bench-connected using the universal cable. There is no need to open the ECU.
It is strictly forbidden to read/write an ECU in the bench leaving the ECU in the engine compartment. This could cause a short circuit and destroy your Autotuner.
Some ECUs do not have a BOSCH port, so they cannot be read using the ATP050 probe. Therefore, it is necessary to use the universal cable and the universal box in order to read this type of ECU.
The universal cable must be connected on one side on the different connectors of the ECU according to the wiring plan and on the other side on the connector «BOOT» of the Autotuner tool.
Reference: FTCABMW20W
BMW 20 pin adapter for 16 pin female OBD / OBD2. Connect your OBD2 diagnostic device to your BMW vehicle equipped with the first generation OBD socket using this 20-pin round socket adapter cable.
Reference: FTCAKWT7W
Reference: FTCAHYU12W-1
This cable is compatible with older models of Hyundai, Mitsubishi or Dodge allows you to connect to your vehicle with a diagnostic device equipped with an OBD EOBD socket.
Reference: FTCSAUOBD001A
The OBD cable connects the AutoTuner tool to the vehicle’s OBD-II diagnostic jack.
Reference: FTCAPSA02W
Adapter cable for old vehicles (before 1993) from the PSA group (Peugeot Citroën). Note: the power cable to power up the diagnostic device and / or the interface is supplied (via the 2 alligator clips).
Reference: FTCAMAN37W
Reference: FTCAPOR19W
19-pin Porsche adapter for OBD/OBD2 16-pin female. Connect your OBD2 diagnostic device to your Porsche vehicle equipped with the first generation OBD plug with this 19-pin adapter cable.