




The 2000 A clamp meter can measure up to 2000 amps without cutting, disconnecting or stripping the wires. Simply tighten the jaws around the cable to be tested and plug the clamp onto your PicoScope 4425A or 4225A
Secure payment - Information protected
Fast delivery - 90% within 2 to 3 days
Returns within 14 days
The ammeter clamps have been designed for use with the PicoScope oscilloscopes and have additional shielding to reduce noise. The Pico TA388 clamp can be purchased as an accessory in one of the current diagnostic kits or individually but requires a PicoScope equipped with the Pico BNC+ like the 4225A or 4425A.
The clamp can be auto-configured by the PicoScope software when connected to the PicoScope. Calibration is performed automatically without any user intervention. The clamp is powered by the PicoScope and therefore does not require batteries. In addition, the clamp is automatically zeroed when connected to the oscilloscope.
The wide range of this clamp can measure currents from less than 1A to 2000 A. It can be used with a PicoScope for many applications, including:
The 2000 A clamp is also equipped with an automatic setting to use the TA388 in many applications where a “low intensity” clamp would normally be required, such as injector and ignition current check.
Model: Pico BNC+ clamp meter: 2000 A AC/DC
Combined cable and probe length: 2.85m
Jaw size: 32mm in diameter
Weight: 320gm
Working current range: 2000 A peak DC or AC
Overload current: 2200 A DC (for one minute)
Maximum voltage and nominal CAT values: 300V
Operating temperature range: 0°C to 50°C
Storage temperature range: -20°C to +85°C
Operating humidity: 15 to 85% (non-condensing)