VGS-190 Digital Vacuum Meter
The VGS-190 digital vacuum meter features a professional vacuum sensor to accurately test the vacuum and obtain accurate vacuum measurements during refrigerant loading.
Venting a HVAC/R system involves venting air and moisture from the system that, if mixed with refrigerants, can produce an acidic chemical reaction, causing long-term system damage. Generally, the vacuum of the system must be less than 700 microns so that the humidity in the system can be effectively reduced. The best vacuum is 300 microns. Ordinary refrigerant gauges cannot meet this requirement. The VGS-190 is used to test system leaks and discern the quality of the vacuum pump.
Technical features:
Measuring range: 0-19000 micron
Operating temperature: 0 ~ 140 (-178 °C ~ 60 °C)
Fitting: 1/4' 'male flared
Auto shutdown time: 15 min
Max Overpressure: 27.5 bar
Accuracy: 10% or 10 microns
Dimensions: 127x 74 x 39mm
Battery life: 300 hours
How to use this product:
1. Press the power button to turn on the gauge before connecting it to a system. It will take 10 seconds for the gauge to warm up. Then it enters the normal display.
2. After power on, the gauge will display “---” if the current pressure exceeds its measurement range. The data is not displayed until the measured pressure is within the range.
Note: Keep the pressure below 27.5 bar, otherwise the sensor may be damaged.
3. Make sure the access system connections and gauge match. If not, please use the supplied adapter.
4. Press and release to turn on the backlight. The backlight will automatically turn off two minutes later.
Press in two minutes to turn off the backlight directly.
5. Press and release UNITS to change unit of measure.
6. Press and release to turn off the gauge. Please use special tools to disconnect it.
Note: Please do not close the vacuum pump before disconnecting it from the system, otherwise high pressure could occur in the system and impurities would enter the sensor cavity.
Warning :
- Please use the gauge in a specified environment to avoid errors or damage to the sensor.
- Please do not use chemical solvent or corrosive liquid to clean the gauge.
- Please do not disassemble the gauge.
- Remove the batteries if the gauge should not be used for a long time in case the leak would corrode the gauge. The included batteries are not rechargeable.